Specification

G. Color:
1. Selected from manufacturer’s standard line.
H. Acceptable manufacturer:
1. SOUTHEASTERN METALS MFG. CO., FL,GA,
[phone]
I. Option manufacturers:
1. DOT METAL PRODUCTS., TX
[phone]
2. CONSTRUCTION METALS, INC., CA
[phone]
3. WEATHER GUARD BUILDING PRODUCTS., CO
[phone]
# Insert: Architect’s method of approval of “or equals.”
J. Other manufacturers desiring approval, comply with Section 01630.
2.02 Fabrication
A. Roll form panels in continuous lengths, full length of detailed runs.
B. Fabricate trim, ashing and accessories to detailed proles.
C. Fabricate trim and ashing from same material as panel.
PART 3 - EXECUTION
3.01 Surface Conditions
A. Inspection:
1. Inspect installed work of other trades and verify that such work is complete to a point where
this work may continue.
2. Verify that installation may be made in accordance with approved shop drawings and
manufacturer’s instructions.
B. Discrepancies:
1. In event of discrepancy, notify Architect.
2. Do not proceed with installation until discrepancies have been resolved.
3.02 Installation
A. Install panels so that they are weathertight, without waves, warps, buckles, fastening, stresses or
distortion, allowing for expansion and contraction.
B. Install panels in accordance with manufacturer’s installation instructions and shop drawings.
C. Provide concealed anchors at all panel attachment locations.
D. Install panels plumb, level, and straight with seams and ribs/battens parallel, conforming to
design as indicated.
5V-CRIMP