Instructions / Assembly

5V-CRIMP PANEL
Fastening Schedule
1. Extrapolation and rational analysis by a Florida Licensed Architect or Structural Engineer is allowed outside the Miami-Dade HVHZ compliance area. 2. Extrapola-
tion and rational analysis shall not be allowed above the maximum tested design pressures within the Miami-Dade HVHZ compliance area. 3. Interpolation is allowed
between Field and Perimeter & Corner test pressure values. 4. For corresponding wind speeds, refer to table 1609.6.2.1(2) of the Florida Building Code. 5. The stated
design pressure can only be achieved by using 19/32” Plywood or OSB decking.
Sidelap Detail
24” Coverage (+/-
1/16
”)
11
1/2
”
7/16
”
Anti-Siphon Channel
Maximum Tested Design Pressures
1,2,3,4
Plywood/ OSB Decking
Min. 15/32” outside Miami-Dade
Min. 19/32” in Miami-Dade
Field
Zone 1
Perimeter and Corners
Zone 2 and Zone 3
Maximum Design Pressure -67.25 psf -67.25 psf -93.5 psf -154.75 psf
5
Maximum Fastener Spacing 16” on center 16” on center 12” on center 8” on center
building or 40% of the mean height of the roof, whichever is smaller,
however, (a) cannot be less than either 4% of the minimum width of
the building or 3 feet.
Roof Zones
Zone 1
Zone 2
a
a
a
a
Zone 2
Eave
Zone 3
Zone 2
Zone 2
Zone 2
Gable
Ridge
Zone 3
Zone 1
1. Code Approval numbers may have changed since publication. For the most recent code approval
numbers, contact Southeastern Metals’ Techincal Department or refer to the appropriate code agency.
Accelerated Testing of coating 2000 hours per ASTM G23.
Salt Spray testing of coating 1000 hours per ASTM B117.
Fire Testing per ASTM E108 or UL790.
Wind Driven Rain Test per TAS 100.
UL Fire Resistance Directory # R20735
UL Maximum Design Pressure Listing # R20735
Miami Dade Code Approval NOA # 07-0815.06
Florida Building Code Approval
# FL-11175
Code Approvals
1
For eaves, ridges and valleys
-67.25 psf
For all intermediate purlins or plywood
-154.75 psf
-93.5 psf
-67.25 psf
O.C. Spacing and Fastening Detail
5V-Crimp Exposed Fastener Panel System
Manufacturers Recommended Fastening Schedule
5V-Crimp Panel and Detail