User Manual

Advanced Settings

Notes:

1) Follow the steps of Advanced Settings ONLY if your access point’s

DHCP setting is OFF. The frame needs to use a fixed IP address to

connect to the AP.

2) If you are using a Wi-Fi network other than your own, then you must

consult the Network Administrator for that network to get access (i.e.

network key).

1. On Network screen, tap the

button on the Advanced Settings line.

The Advanced Settings screen will appear.

2. On the DHCP line, select On or Off. Normally the DHCP is ON and the

frame can get the IP address assigned by the access point. If the DHCP

is OFF, the frame will use a fixed IP address to connect to the access

point.

3. If the DHCP is OFF, then you need to input the following settings:

 IP Address

 Subnet Mask

 Default Gateway

 DNS Server

4. Tap

to open the Keyboard and type in the required settings. Tap OK

to save your entries.

5. On the Save line:

 Tap Yes to save the advanced network settings and go back to the

Network screen.

 Tap No to cancel without saving and go back to the Network screen.

6. On the WiFi line, tap the On button to turn on WiFi.

7. Next, on the Search WiFi Network line, tap

to begin searching for all

available Access Points (AP).

 All the available access points and their signal strength are listed in

Network > Search screen.

Advanced Settings screen (DHCP is OFF)

Network Settings screen

Wi-Fi Network Search screen