Product Info

Operatiom
This section describes how to
1.Answer an incoming external call
(from the PSTN line)
2.Answer an internal call (intercom)
3.Make an external outgoing call
4.Make an internal call
5.Forward an incoming external
call to the other handset
6.Setup a conference call (with the
other handset and an external party)
7.Redial (last number called)
8.Perform a Page call
9.Use the Flash function (also
denoted Register Recall)
Idle State
The idle state reflect the situation
where the handset is registered and
inside range of the base station, not
engaged in an ongoing call and not
in programming mode.
1.The idle state is indicated by a
"READY"-message in the display.
2.If the handset is not registered,
"NOT REGISTERED" and
"PLACE IN BASE" will be
displayed.
Incoming Call
The same procedure applies to all
incoming calls, i.e. external and
internal (intercom and conference
call).
Incoming Call Base station
1.External call without caller ID.
2.If the central office sends the
caller ID information, the calling
number will be displayed.
3.If the calling number matches a
number in the Mem, the name
associated with this number is also
shown.
Incoming Call - Handset
1.If auto answer is disabled, an
incoming call is accepted by
removing the handset from the base
or
2.the charger, and pressing TALK
or any numerical key (0 to 9), * or #
key. If auto answer is enabled, the
incoming call is accepted by
removing the handset from the
charger.
3.The call is terminated by
pressing TALK Or placing the
handset in the charger.
Display presentation during
incoming call sign a ling
At the event of an incoming call,
depending on the type of call, the
following information is shown on
the display.
1.External call without caller ID.
2.Internal call (intercom): (from h
s1).
3.Example where no Name is
assigned to calling handset.
4.Example where Name is assigned
to calling handset.
5.Call back (forwarded call was not
answered).
6.Base call.
7.If the central office sends the
caller ID information, it is shown
in the display instead of 'external
call' or 'call back'. The caller ID
either shows the calling number
alone.
CALL MANAGEMENT
14