DC TO AC POWER INVERTER USER'S MANUAL Model: PM-1600KAR □ PM-2000KAR □ PM-2500KAR □ PM-3000KAR □ Warning: This manual contains important safety and Service support: support@giandel.com.au operating instruction. Please read it carefully before use the unit.
Specifications: Item Item PM-1600KAR PM-1600KAR PM-2000KAR PM-2000KAR 12VDC 24VDC 12VDC 24VDC Rated input voltage 12VDC 24VDC 12VDC 24VDC Continuous power 1600W 1600W 2000W 2000W Continuous power 2500W 2500W 3000W 3000W Peak power 3200W 3200W 4000W 4000W Peak power 5000W 5000W 6000W 6000W 9.8~16VDC 19.6~32VDC 9.8~16VDC 19.6~32VDC 9.8~16VDC 19.6~32VDC 9.8~16VDC 19.
1. Brief Our power inverter is an advanced tool of power conversion, and it can supply you with AC power converted from DC power source. Not only can be used in cars, vessels and camping, but also can be used in emergency the power fails. In order to use the inverter efficiently and safely, please install and use it in a proper way. Please read the instruction carefully before installing and using the appliance. 2. Warning and safety 1) Read the manual before use and keep it for future reference.
3. Remote controller box Normal working indicator Power switch (Switch) Fault indicator Remote interface Connecting wire 4. Assembe 1.
The ground terminal has already connected to the ground wire of AC output receptacle through the internal connecting wire. The ground terminal must be connected to the ground wire, which will vary depending on where the power inverter is installed. In a vehicle, connect the ground terminal to the chassis of the vehicle. On the ship, connect the ground terminal to the ship grounding system; In a fixed position, connect the ground terminal to the earth. Warnings: ● To make sure the firmness of the connection.
Warnings: 1.Make sure that the switches of the inverter and appliance power are in OFF position before connection. 2.Check the power cord. If it is damaged, it should be connected after replacement. 3. Each outlet of the inverter has a given current rating of the manufacturer. It shall not exceed this value during use. Otherwise, the socket may be damaged by overheating and may cause an electric shock.
2) Connect the solar panel’s positive and negative electrode to the positive and negative terminal of the solar input of inverter, pay attention to the correct polarity. 3) Normal charging panel quantity of electric charge indicator lights light up, the user can know the size of the battery charging voltage, when the "full" indicator lights up, indicating that the battery is fully charged, the user should promptly disconnect the solar cell and product connected to stop charging, avoid overcharge.
2. Under voltage protection: The inverter will automatically shut down when the input DC voltage is lower than 9.5V(19V/38V).The buzzer will whistle continuously and the green light is off, red light is on. Please turn off the inverter and use it after recharging the battery. 3. Over voltage protection: The inverter will automatically shut down when the input DC voltage is higher than 16V(32V/62V).The buzzer will whistle continuously and the green light is off, red light is on.