Installation Guide

ManualsBrandsGiagni ManualsBathtub FaucetsTWTF-C-PC

TRADITIONAL FLOOR MOUNT TUB FAUCET (cont.)

End View

Side View

Step 6 Slide #25 decorative escutcheon onto

bottom of risers U-FRSR and push part way up.

Screw #26 floor flange onto threaded portion of

each riser until it stops.

Step 7 Insert risers into hole in floor and secure

floor flanges with appropriate screws/bolts for your

flooring type. (Hardware not included)

Step 8 Slide decorative escutcheon down to cover

floor flange.

Step 9 Tighten optional support bracket to risers

and drain

Dimension X

If using support bracket

3-3/4”

If NOT using support bracket

2-1/2” TO 3-1/2”

Step 4 Drill (2) 1-1/8” holes into floor on 8” centers

for hot and cold water supplies. If using U-SBRC

support brace, water supply holes must be drilled

at 3-3/4” from drain outlet (center to center). If not

using support brace, holes should be drilled at

2-1 /2” minimum to 3-1/2” maximum from drain outlet

(center to center).

Step 5 If desired, attach U-SBRC support bracket

to risers. See page 7. (Tub model LCAT-167 does

not have an exposed drain so support brace will not

be used)

Step 10 Attach small end of #18 hand shower hose

with #28 washer to outlet on side of #1 hand

shower holder.

Step 11 Attach large end of #18 hand shower hose

with #28 washer to #6 hand shower and place in

#1 holder.

Step 12 Connect preferred ½” pipe (supplied by

installer) into female threaded riser U-FRSR from

under flooring. Make hot/cold water connections.

Turn on water and check all connections for leaks.

NOTE: When using the

U-SBRC support brace

it must be installed onto

faucet risers prior to

securing to floor

U-SBRC

Tub

Decorative

Flange (25)

Floor Flange

(26)

See Step 4

Washer

1/2" NPT Female Adapter

large end

Small

end