Installation Guide

8
TRADITIONAL WALL MOUNT TUB FAUCET
Notes:
1. Please ensure all local plumbing and building codes are observed when installing
these faucets.
2. Mounting location depends on tub design and location. Be sure to identify tub height
when determining faucet location.
3. There must be a minimum of 2" gap between top of tub rim and bottom of the faucet
spout to comply with plumbing codes. (See fig. 4)
4. Water supply lines must be roughed in on 8” centers.
Step 1
Screw #11 handle hub onto hot/cold cartridges
#9 and #17. Disassemble handle and install
onto cartridge by securing with screw included.
Reassemble handle.
Step 2 Rough-in #23 T-WLBO flush to finished
wall. Hot/Cold supplies should be roughed in on 8”
centers and 1/2” pipe (supplied by installer) should
extend 3/8” to 1/2” beyond the finished wall.
Step 3 Screw decorative flange #22 included with
T-WLBO onto rough portion #23.
Step 4 Attach faucet to wall by screwing union nuts
onto the T-WLBO wall elbows with #10 washer.
NSF /ANSI 61
Finished Wall
3/8"-1/2"
T-FB1
T-WLBO (23)
Union Nut
Pipe Nipple
Decorative Flange (22)
Washer (10)
17
11
9
T-HLVR
11
White Porcelain
11
T-HPLV
T-HCRS
Pipe
Finished Wall
Rough-in T-WLBO
Flush to finished wall.
Pipe nipple should extend
3/8" - 1/2" beyond finished
wall.
Nipple
Decorative
Flange
1/2
-
14
NPT