Installation Sheet

Giagni

TRADITIONAL DECK MOUNT OPTIONAL SHUT OFF VALVE

Step 1 Screw handle hubs onto valve stems. Disassemble handle and install onto stem by securing

with screw included. Reassemble handle. NOTE: Rotate valve stem counter-clockwise until it stops to

open valve prior to installing handle. Handle must be installed pointing up.

Step 2 Slide decorative ange onto bottom of U-DVLV stop valve. (Note: Slide slowly to avoid

scratching nish) Connect stop valve to ½” coupling, supplied by installer, below the oor. Slide

decorative ange down to oor.

Step 3 Cut U-FSUP supply line to appropriate length and connect to stop valve with nut, metal

washer and cone washer. Proceed with Step 5 on page 3 to complete faucet installation.

Valves In Open Position

Valves In Closed Position

White Porcelain

Handle Hub

T-HLVR

T-HPLV

T-HCRS

Cone Washer

Valve Stem

Metal Washer

Nut

U-DVLV

Cone Washer

U-FSUP

Supply Line

1/2" Pipe

1/2" Coupling

Metal Washer

Nut

U-DVLV

Stop Valve

Floor

Decorative Flange

NUT

WASHER

LOCK NUT

RUBBER SEAL WASHER

CONE WASHER

T-DLBO

T-FB1

U-FSUP

NOTE: U-FSUP SUPPLY LINES CAN

BE CUT TO CORRECT HIEGHT.

MAKE SURE TO CUT FROM

BOTTOM OF TUBE.

U-DVLV