Installation Sheet

8
Giagni
TRADITIONAL WALL MOUNT TUB FAUCET
NSF /ANSI 61
Finished Wall
Pipe Nipple
Decorative Flange (22)
T-WLBO (23)
Washer (10)
T-FB1
Union Nut
3/8"-1/2"
Notes:
1. Please ensure all local plumbing and building codes are observed when installing
these faucets.
2. Mounting location depends on tub design and location. Be sure to identify tub height
when determining faucet location.
3. There must be a minimum of 2" gap between top of tub rim and bottom of the faucet
spout to comply with plumbing codes. (see g. 4)
4. Water supply lines must be roughed in on 8” centers.
T-HLVR
T-HPLV
T-HCRS
11
9
11
11
17
White Porcelain
Step 1
Screw #11 handle hub onto hot/cold cartridges
#9 and #17. Disassemble handle and install
onto cartridge by securing with screw included.
Reassemble handle.
Step 2 Rough-in #23 T-WLBO ush to nished
wall. Hot/Cold supplies should be roughed in on 8”
centers and 1/2” pipe (supplied by installer) should
extend 3/8” to 1/2” beyond the nished wall.
Step 3 Screw decorative ange #22 included with
T-WLBO onto rough portion #23.
Step 4 Attach faucet to wall by screwing union nuts
onto the T-WLBO wall elbows with #10 washer.
Finished Wall
Decorative
Flange
Pipe Nipple
TPN 41 - 2/1
Rough-in T-WLBO
Flush to finished wall.
Pipe nipple should extend
3/8" - 1/2" beyond finished
wall.