Installation Guide

1. Ensure tub surface is protected during assembly, installation and the nal phase of

construction.

2. Place tub on oor, upside down, and attach feet to tub with fasteners provided.

Do not overtighten.

3. Turn tub right side up, place in desired position and mark foot anchoring locations.

4. Carefully move tub and drill (4) 7/16” diameter holes in the oor to accommodate the foot anchors.

5. Place tub back in position, dropping the threaded studs into the holes in the oor.

This will prevent the tub from sliding on the oor. If needed, adjust the height of the disc on the

threaded stud to level the bathtub.

NOTE: We strongly recommend that you secure the tub to avoid any tub movement and possible

damage to water supply lines. However, if you choose to not secure the tub, the adjustable

disc can be moved to the end of the threaded stud to create a at surface for the tub to sit on.

The threaded stud can then be screwed up/down to level the tub as needed

TUB BOLT

NUT

LOCK WASHER

PLAIN WASHER

FOOT

ADJUSTABLE DISC

THREADED STUD

DRILLED ANCHOR

HOLE

FLOOR

TURN ADJUSTABLE DISC UP/

DOWN TO LEVEL TUB, AS NEEDED

SCREW THREADED STUD UP/DOWN TO DESIRED

HEIGHT BASED ON DEPTH OF THE HOLE IN THE FLOOR

Please leave this sheet and warranty for the customer for future reference

CANNON BALL AND BALL & CLAW FEET

Installation Instructions

1 888 560-5222 USA

8 a.m. to 6 p.m. EST Monday-Sunday

For additional assistance or service call:

Para servicio o ayuda adicional, Ilame al:

Giagni