Installation Guide

Giagni

INSTALLING RECTANGULAR FEET

#1 Threaded Stud

#2 Adjustable Disc

#5 Nut

#3 Bolt

#8 Chrome Plated

Rectangular Feet

#4 Washer

#6 Washer

#7 Mounting Bracket

1. Ensure tub surface is protected during assembly, installation and the nal phase of construction.

2. Attach the mounting brackets (#7) to the base of the bathtub with the round hole facing outward and

secure with the nuts (#5) and washers (#6) supplied. Do not over tighten.

3. Align the chrome plated rectangular feet (#8) with the round location holes in the mounting brackets and

secure with the bolts (#3) and washers (#4).

3. Turn tub right side up, place in desired position and mark foot anchoring locations.

4. Carefully move tub and drill (4) 7/16" diameter holes in the oor to accommodate the foot anchors.

5. Place tub back in position, dropping the threaded studs into the holes in the oor. This will secure the

the tub and prevent it from sliding on the oor. If needed, adjust the height of the disc on the threaded

stud to level the bathtub.

NOTE: We strongly recommend that you secure the tub to avoid any tub movement and possible damage

to water supply lines. However, if you choose to not secure the tub, the adjustable disc can be

moved to the end of the threaded stud to create a at surface for the tub to sit on. The threaded

stud can then be screwed up/down to level the tub as needed

Floor

Drilled Anchor Hole

Turn adjustable disc up/down to

level tub, as needed

Screw threaded stud up/down to desired

height based on depth of the hole in the

oor