Installation Guide
3
Giagni
Before you begin:
• Observe all local plumbing/building codes and ensure ooring support is adequate. Installation of
backow prevention must comply with local codes and regulations. In certain states models with
handshower must be installed with a listed inline anti-scald device.
• Before you begin work, carefully uncrate and inspect the tub for any damage. If there is a
problem, do not install the tub. Immediately report the problem to the dealer.
• Ensure the oor will support 1200 lbs. (This is the approximate weight of the tub lled with water
and bather.)
• Carefully plan the moving of the bath into the installation area. These bathtubs may not easily t
through doorways.
• Before installation, ensure proper access to the nal plumbing connections.
Safety instructions:
To reduce the risk of injury:
• Do not permit children to use this unit unless they are closely supervised by an adult at all times.
Supervision is also required when the bath is used by an elderly or handicapped individual.
• Use this unit only for its intended use as described in this manual. Do not use attachments not
recommended by the manufacturer.
• Since excessive water temperatures have a high potential for causing fetal damage during
the early months of pregnancy, pregnant or possibly pregnant women should limit bath water
temperatures to 38° C (100° F).
• The use of drugs or alcoholic beverages before or during bath use may lead to unconsciousness
with the possibility of drowning.
• Persons with a medical history of heart disease, low or high blood pressure, circulatory system
problems, or diabetes should consult a physician before using the bath.
• Persons using medication should consult a physician before using the bath since medication may
induce drowsiness while other medication may affect heart rate, blood pressure and circulation.
DANGER: To reduce the risk of injury, enter and exit the bath slowly.
WARNING: Never operate electrical devices in or near the bath. Never drop or insert any object into
any opening within the bath.
To avoid the possibility of personal injury and discoloration of the acrylic surface, the inlet water
temperature should not exceed 60° C (140° F) and the bath should be drained after each use.