Installation Guide

11
Giagni
INSTALLING THE DRAIN
STEP 4
1. Connect Drain Strainer & Drain Ell. Use silicone sealant. DO NOT use plumbers putty to seal.
2. Insert tailpiece into trap inlet. The tailpiece may need to be cut for proper t. 1"- 2" of the tail
piece should t inside the trap. Slip the ange over the tailpiece and slide down to oor.
3. Assemble tee section to Tailpiece, overow ell and drain ell using coupling nuts and O-rings
that are provided.
4. Attach the tapered rubber gasket to the overow ell. Align the overow ell with the overow
hole and secure drain to the tub with overow plate and screw provided.
5. Make sure a watertight seal exists on all bath drain connections.
FIGURE 1 Connect strainer to drain ell FIGURE 2 Connect tailpiece to trap inlet
FIGURE 3 Assemble tee section FIGURE 4 Secure drain to tub with overow plate
Strainer
Silicone
Sealant
Drain Ell
Gasket
Tailpiece
O-ring
Flange
Trap Inlet
Coupling Nut
Overflow Ell
Te e
Coupling Nut
O-ring
Overflow Plate
Tapered Rubber Gasket