Installation Guide

10
Giagni
INSTALLING CRADLE
Leveling
Feet
4 Pcs
1
Mounting
Bolt
8 Pcs
2
Suction
Cup
4 Pcs
3
Decorative
Plug
8 Pcs
4
Cylinder
Nut
8 Pcs
5
Wood Dowel
Pins
8 Pcs
6
1. Leveling
Feet
6. Wood Dowel Pins
3. Suction Cup
4. Decorative Plug
2. Mounting Bolt
5. Cylinder Nut
Side Rails
End Assembly
Leveling
Feet
4 Pcs
1
Mounting
Bolt
8 Pcs
2
Suction
Cup
4 Pcs
3
Decorative
Plug
8 Pcs
4
Cylinder
Nut
8 Pcs
5
Wood Dowel
Pins
8 Pcs
6
1. Leveling
Feet
6. Wood Dowel Pins
3. Suction Cup
4. Decorative Plug
2. Mounting Bolt
5. Cylinder Nut
Side Rails
End Assembly
1. Loosely connect the End Assemblies with the Side Rails
using the Wooden Dowel Pins (#6) in the top holes. The
two Side Rails with the curved notches to accommodate
the tub drain need to be on the same side. Place the more
extremely tapered Rail on top as shown in detail.
2. Insert the Cylinder Nuts (#5) all the way into the inside holes
on the Side Rails with the slot facing out, and the slot parallel to the Side Rail.
3. Insert the Mounting Bolts (#2) into the through holes in the End Assemblies and screw them
partially into the Cylinder Nuts (#5). Use a screwdriver to re-align the Cylinder Nut slot to be
parallel to the Side Rail if necessary.
4. After all the bolts are installed, tighten them rmly with the supplied Allen wrench.
5. Insert Decorative Plugs (#4) into bolt heads.
6. Position tub inside cradle.
7. Position Tub and Cradle in room and level using #1 Leveling Feet.
CURVED NOTCHES
TOP RAIL