Installation Guide

For additional assistance or service call: 1-888-560-5222 USA 8:30 a.m. to 5:30 p.m. EST Monday-Sunday
NSF /ANSI 61
Giagni
KPT
KPT100
Important notices before starting installation:
• This faucet must be installed by a qualied licensed plumber in accordance with all local city and state
plumbing codes
• Customer is to determine installation height above stove or cook top
• Install a supply stop valve on cold water line where accessible then route water supply to the installation area
• Maximum operating pressure is 125 PSI
• Read entire instructions before installing
Step 1- Before installing the faucet the stove or cook top should be removed or covered in plastic to prevent any possible
water damage. Electric stoves must have the circuit breaker in the off position.
Step 2- Strap ½” water supply to stud or backing inside wall to keep from moving (Fig. 1).
Step 3- Rough-in so that ½” threaded pipe nipple protrudes approximately ½” beyond nished wall (Fig. 2).
Step 4- Apply Teon tape to exposed pipe nipple then screw on quick connector COU-PF so it is ush to nished wall.
Secure by tightening set screw KPT-03 with wrench provided KPT-11.
Step 5- Rotate faucet until correct alignment is made (spout should be pointing straight down) Fig. 3. Push the faucet body
onto the quick connector over the two o-ring seals KPT-02. The splines inside the faucet body should line up with the
splines on the quick connector.
Step 6- Secure faucet by tightening the two bottom set screws KPT-03.
KPT100 (1/23/09) ©GIAGNI COLLECTION 2009
COU-PF
KPT-02
KPT-04
KPT-03
Strap
Rotate Body On Splines of
KPT-01 for Proper Alignment
(FIG. 3 )
Approximately 1/2” Exposed of 1/2”
Pipe Nipple
(Fig. 2 )
Cold Water In
(FIG. 1 )
Finished Wall
Push On
Pot Filler Installation Instructions