Installation Sheet

1
Giagni
CONTEMPORARY FLOOR MOUNT TUB FAUCET
NSF /ANSI 61
3
7
(Allen Wrench)
1
Step 1 Install #1 spout into
faucet body by pushing straight
down. Align spout facing forward
then tighten with #3 allen screw
(packaged separately with #7 allen
wrench). Do Not Over Tighten.
Step 3 Attach hot and cold risers
C-FRSR to union nuts on back of
faucet body using one #10 rubber
gasket on each riser.
Step 2 Screw #16 handle hub
onto hot/cold cartridges #9 & #17.
Disassemble handle by unscrewing
spokes
and install onto cartridge
by securing with screw included.
Reassemble handle.
1
10
C-FRSR
Union Nut
C-HLVR
17
9
C-HCRS
16
16
Screw
Spokes
Spokes
Tub
Drain
Washer
C-FB1
C-FRSR
Optional
Support Brace
U-SBRC
Floor Flange (26)
MIN. 3-3/4"
MAX. 5-1/2"
Decorative
Escutcheon (25)
C-FRSR
Step 4- Drill (2) 1-1/8” holes into oor on 8”
centers for hot and cold water supplies (see
g. 5 next page). Supply holes should be
drilled at 3 ¾” minimum to 5 ½” maximum
from drain outlet (center to center).
Step 5- If desired, attach U-SBRC support
bracket to risers. See page 4. (Tub model
LCAT-167 does not have an exposed drain so
support brace will not be used)
Step 6- Slide #25 decorative escutcheon
onto bottom of risers C-FRSR and push
part way up. Screw #26 oor ange onto
threaded portion of each riser until it stops.
Step 7- Insert risers into hole in oor and
secure oor anges with appropriate screws/
bolts for your ooring type. (Hardware not
included)
Notes:
1. Faucet is not for use on concrete oors.
2. Please ensure all local plumbing codes are observed during installation
3. Water supply lines must be roughed in on 8” centers.
NOTE: When using the
U-SBRC support brace
it must be installed onto
faucet risers prior to
securing to oor