SDS
Components with workplace control parameters
CAS#: 64741-65-7 Naphtha (petroleum), heavy alkylate, Value type: TWA, Control parameters: 500 ppm, 2000 mg.m3 Basis: OSHA Z-1
CAS#: 64741-65-7 Naphtha (petroleum), heavy alkylate, Value type: TWA, Control parameters: 400 ppm, 1600 mg.m3 Basis: OSHA P0
CAS#: 64-17-5 Ethanol, 1000 ppm, 1000 mg.m3, OSHA PEL
Engineering controls
Ventilation:
Use with adequate ventilation.
Local exhaust:
To control flammable/combustible vapors: Local exhaust ventilation which meets the requirements of ANSI Z9.2 is recommended to
control airborne contaminants at the point of use. (to maintain concentration below TLV) .
Personal protection equipment (PPE): Respiratory protection is not normally required and only necessary if long term or high level
exposures are likely to occur. A NIOSH approved air purifying respirator equipped with universal multi-contaminant multi-gas/vapor
cartridges is recommended if over exposure to chemical vapors could occur.
Hand protection:
Butyl rubber protective gloves or neoprene or nitrile rubber gloves .
Eye protection:
Safety glasses with side shields or chemical safety goggles. Where there is risk of splashing: tight fitting chemical safety goggles. Eye
was bottle with pure water. Wear face-shield and protective suit for abnormal processing problems.
Skin and body protection Impervious clothing, choose body protection according to the amount and concentration of the dangerous
substance at the work place.
Other protective clothing or equipment:
Additional protective clothing or equipment is not normally required. Provide eye bath and safety shower.
General hygiene and protection measures: Avoid contact with eyes, skin and clothing. Avoid breathing dust/vapor/mist/gas/aerosol.
When handling do not eat, drink, smoke or apply cosmetics. Wash thoroughly after handling.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Appearance
Physical state / form ................................................: liquid
Colour .....................................................................: clear to yellowish
Odour ......................................................................: hydrocarbon-like
Safety parameters
Boiling point / boiling range Value: not determined
Flash point Value: not determined
Ignition temperature: not determined
Lower explosion limit (LEL): not determined
Upper explosion limit (UEL): not determined
Vapour pressure: not determined
Density: not determined
Water solubility / miscibility: not determined
pH-Value: not applicable
Furthur information: Expolsion limits for release ethanol: 3.5-15% (V)
SECTION 10: STABILITY AND REACTIVITY
General information: If stored and handled in accordance with standard industrial practices no hazardous reactions are known.
Chemical stability stable under normal conditions
Possibility of hazardous rections: Vapors may form explosive mixture with air.
Conditions to avoid: moisture, heat, open flames, and other sources of ignition.
Materials to avoid: Reacts slowly with: water, basic substances and acids. Reaction causes the formation of: methanol, ethanol.
Incompatible materials: strong oxidizing agents, strong reducing agents
Hazardous decomposition products: Carbon oxides, Sulphur oxides. The following applies for the silicone content of the substance:
Measurements have shown the formation of small amounts of formaldehyde at temperatures above about 150 C (302 F) through
oxidation. By hydrolysis: methanol, ethanol.
Further information: Hazardous polymerization cannot occur.