TDS

!
Technical Data Sheet
8525
PRODUCT DATA
Sections
APPLICATION
KreteTek Industries Inc. 66 River Road Hudson, NH 03051 // 855-573-8383 // www.ghostshield.com
03
Surface Prep
1. Surface and air temperatures must be at least 50°F during and
within two hours of application. Do not apply within 5°F of the dew
point or when temperatures are expected to fall below 32°F within 8
hours or when rain is expected within 12 hours following
application. Keep material from freezing. Do not apply during
inclement weather or when inclement weather is expected within 12
hours. Condition material to be a minimum of 60°F prior to
application.
5. Protect people, property, vehicles, window glass, roofing materials,
plastic products, shrubbery, landscaping and all surfaces not set for
treatment from overspray.
Application
1. Always test a small area before application to ensure desired
performance, aesthetics, coverage rates and to verify application
technique.
2. Stir material throughly before and during application. Do not
dilute or alter material for purposes other than specified.
3. Apply as soon as all bleed water has dissipated and within 2 hours
of final finish. Applying after 2 hours may result in blotchiness,
blistering and peeling. Apply uniformly leaving no pinholes or gaps.
Do not allow the material to puddle. Do not apply over free standing
water. If it starts to rain, stop treatment and cover the impregnated
areas. Spray Apply: Use a low pressure, airless sprayer equipped with
a fan nozzle orifice of 0.030” to 0.035” at 1 gallon per minute. The
optimum spray pattern is an 8” to 12” fan, hold sprayer top 8” to 12”
from the surface of the concrete. Roll Apply: May be applied with a
short nap (1/4” max) roller.
Dry Time
Typical drying time is 1 hour at 70°F and 50% relative humidity.
Cooler temperatures or higher relative humidity can extend the
drying time. Treated surfaces will be ready for pedestrian within 8
hours and vehicle traffic within 24 hours. Water repellency will
continue to develop within 7 days of application.
Clean Up !
Clean equipment, tools and surfaces with hot soapy water. Unused or
old material may be disposed of in a waste disposal site in
accordance with local, state and federal laws.
Precautions/Safety
Avoid contact with skin, eyes and clothing, do not take internally. Use
appropriate safety equipment during application and handling.
Please refer to the safety data sheet (SDS) for additional
precautionary instructions before use.!
3
03 39 00
Concrete Curing