Instructions / Assembly

ManualsBrandsGHOST CONTROLS ManualsAutomatic Gate OpenersArchitectural Series Solar Single Automatic Gate Opener Kit

SYSTEM SAFETY

©Ghost Controls 2017 | www.GhostControls.com

This manual contains important safety precautions and

warnings for both the installer and end users or consumers

of this automatic gate opener system. The following warn-

ings and safety are intended to apply to the most common

applications but may not apply to all possible installation and

applications for these products. To reduce risk of injury or

death:

1. CAREFULLY READ AND FOLLOW ALL SAFETY

PRECAUTIONS, WARNINGS, INSTALLATION

AND OPERATING INSTRUCTIONS.

2. DO NOT ALLOW CHILDREN TO OPERATE

GATE CONTROLS. Do not allow children or pets

to play near the gate opener system. Keep all gate

control accessories such as remote transmitters,

keypads, and push buttons out of reach of children

and store in a secure area when not in use.

3. Understand how to disconnect the power and

manually open the gate (beginning on page 61)

BEFORE you begin using the gate opener system.

If you are unsure of any of these steps, please

contact GHOST CONTROLS

Technical

Support at 850-898-1411 or online at

https://ghostcontrols.support.com.

4. Disconnect the gate operator from the gate only when

the gate is not in motion and the opener system is

turned o.

5. Moving gates can be dangerous. No one, including

people or animals, should cross the path of a moving

gate. Maintain a safe distance from moving parts

and avoid any areas where hands or ﬁngers could be

pinched.

6. Become familiar with potential entrapment zones as

shown in diagram and avoid these areas when the gate

is turned on.

7. The gate opener system must be installed only in

applications that it is speciﬁcally designed for including:

frequency of use, length, and weight of the gate.

8. The gate opener system and installation must comply

with any applicable local codes.

9. Install the gate operator system on the inside of the

property, gate, or fence line to prevent public access

to it. Most applications are installed in a pull-to-open

conﬁguration so that the gate opens into the property

and away from any public roads.

10. The control board for the gate operator system should

be protected from unauthorized access inside the con-

trol box to prevent tampering or adjustments to its set-

ting once installed. The control box is designed so that

a lock can be attached to keep the box securely closed.

An accessory Operator Security Lock Kit (AX3L) is

available for purchase that includes a lock for the con-

trol box, battery box, along with a replacement clevis

pin and lock to secure the operator to the gate itself.

11. Keypads and push-buttons to activate the gate opera-

tor system must be a minimum of 10’ away in direct line

of sight visibility to the gate so that the user can verify

that any potential entrapment areas are clear

of potential obstructions.

Grey Indicates Potential

Entrapement Areas

OPTIONALPHOTO BEAM

OPTIONAL PHOTO BEAM

OPTIONAL

PHOTO BEAM

SYSTEM SAFETY

GATE OPENER SYSTEMS