Instructions / Assembly

6
READ ME FIRST
©Ghost Controls 2017 | www.GhostControls.com
B. Gate should be completely supported by mount-
ing hinges. It may be necessary to add additional
hinges to some gate installations.
C. Gate should be level, plumb, and move freely in
both directions when minimal force is applied in
the opening or closing direction.
D. Gate should NOT open uphill or downhill.
9. The vehicular entry gate system must be installed
in a location that prevents entrapment by providing
sucient clearance between it and adjacent structures
when opening and closing.
10. Never let children operate or play with gate controls.
Keep the remote control away from children.
11. When planning a system that will allow entry from a
busy road or highway, make sure the system is placed
far enough from the road to prevent trac
congestion.
12. Swing gate systems must not open into public access
areas or into the road which could cause collision with
a moving vehicle.
13. Test the gate operator monthly. The gate MUST
reverse on contact with a rigid object or stop when
an object activates the non-contact sensors. After
adjusting the force or the limit of travel, retest the
gate operator. Failure to adjust and retest the gate
operator properly can increase the risk of injury or
death.
14. KEEP GATES PROPERLY MAINTAINED. Read
the user’s manual. Have a qualified service person
make repairs to gate hardware.
15. SAVE THESE INSTRUCTIONS.