Manualshelf

Instructions / Assembly

ManualsBrandsGHOST CONTROLS ManualsAutomatic Gate OpenersArchitectural Series Solar Single Automatic Gate Opener Kit
41424344454647484950
48
BATTERY BOX
©Ghost Controls 2017 | www.GhostControls.com
48
STEP 3: ATTACH POWER HARNESS TO SYSTEM CONTROL BOARD
A. Turn the power switch to the GHOST CONTROLS
®
control box to the off position before making
connections.
B. Feed the power harness out of the battery box through its strain relief and up into system control box
through the strain relief on the bottom of the control box. See image below.
C. Connect the two bullet connectors from the battery box harness to the bullet connectors of the control
board as shown below.
Route power cable from inside of battery
box through the strain-relief, then into the
control box through its strain-relief.
Once routed into the Control Box (as shown),
connect the terminals of the power cable.
(Batteries not shown.)