Instructions / Assembly

35
PUSH-TO-OPEN
Ghost Controls 2017 | www.GhostControls.com
STEP 6. DRILLING REAR BRACKET HOLES AND BOLTING.
A. With the post bracket still clamped to post you will need a 3/8” drill bit and drill the (4) holes to mount
the rear bracket to the post.
TIP: Drill each hole one at a time and insert a bolt through to ensure that the holes are all aligned.
B. Insert (1) M-10-175mm bolt, and (1) flat washer thru the rear post bracket hole on the post and secure on
backside with (1) flat washer and (1) M10 locknut as shown and loosely tighten to secure the rear bracket
to the post. Repeat this 3 more times for the other bolts. Once all 4 bolts are in place you can firmly
tighten them
STEP 7. FINISHING POST BRACKET ASSEMBLY.
THE REAR MOUNT POST BRACKET ASSEMBLY SHOULD REMAIN CLAMPED TO THE POST DURING
THIS PROCESS. Verify STEP 5 is complete and the bolts are tight to the post bracket in STEP 6, place the secondary
bolt into the post bracket as shown. Insert the M10x1.5x75mm bolt and M10 washer through the post bracket outer hole,
then first push-to-open bracket, pivot spacer, second push-to-open bracket, and exit bottom hole of post bracket as
shown below. Fasten a M10 washer and M10 locknut on the end of the bolt. Finish by tightening both bolts on post
bracket.