Instructions / Assembly
32
DTP1 KIT
Ghost Controls 2017 | www.GhostControls.com
STEP 2. ESTABLISH AND MARK THE HORIZONTAL CENTER LINES OF THE GATE AND
THE POST FOR PROPER ALIGNMENT OF GATE BRACKETS.
NOTE
This center point will be used for mounting the post bracket in STEP 4.
STEP 3. POST BRACKET PREASSEMBLY.
YOU WILL NEED TO MAKE SURE
YOU PURCHASE THE PUSH
TOOPEN BRACKET KIT AXPO
BEFORE YOU START THIS STEP.
Insert the M10x1.5x75mm bolt and M10
washer through the hole that is closest
to the post on the post bracket. Bolt
should then go through first push-to-
open bracket, pivot spacer, second push-
to-open bracket, and exit bottom hole
of post bracket as shown. Fasten a M10
washer and M10 locknut on the end of
each the bolts. DO NOT overtighten the
nuts because the Push-To-Open brackets
may need to be adjusted later.
PUSH-TO-OPEN
BRACKET
PUSH-TO-OPEN
BRACKET
NYLON PIVOT SPACER
COMPLETED ASSEMBLY
M10 X 1.5 X 75MM BOLT
M10 WASHER
M10 WASHER
M10 LOCKNUT
POST
BRACKET