Instructions / Assembly

28
DTP1 KIT
Ghost Controls 2017 | www.GhostControls.com
E. Assemble clevis pin, front spacer and hair pin to operator to prevent loss.
F. Now you can mark and drill the inner most hole on the gate bracket, shown below.
G. Align the innermost holes of both the estate and the gate brackets and insert (1) M8 x 65mm flat washer,
and (1) M8 nylon locknut thru both holes and tighten to secure the brackets to the gate. YOUR GATE
BRACKET AND ESTATE BRACKET SHOULD NOW BE ATTACHED AND SECURED TO THE GATE.