Instructions / Assembly

23
PULL-TO-OPEN
Ghost Controls 2017 | www.GhostControls.com
STEP 6. DRILLING REAR BRACKET HOLES AND BOLTING.
A. With the post bracket still clamped to post you will need a
3/8” drill bit and drill the (4) holes to mount the rear post
bracket to the post
TIP: Drill each hole one at a time and insert a bolt through to
ensure that the holes are all aligned.
B. Insert (1) M-10-175mm bolt, and (1) flat washer thru the rear
post bracket hole on the post and secure on backside with (1)
flat washer and (1) M10 locknut as shown and loosely tighten
to secure the rear bracket to the post. Repeat this 3 more
times for the other bolts. Once all 4 bolts are in place you
can firmly tighten them.
STEP 7. FINISHING POST BRACKET ASSEMBLY.
THE REAR MOUNT POST BRACKET ASSEMBLY SHOULD REMAIN CLAMPED TO THE POST DURING
THIS PROCESS. Verify STEP 5 is complete and the bolts are tight to the post bracket in STEP 6, place the secondary
bolt into the post bracket as shown. Insert the M10x1.5x75mm bolt and M10 washer through the post bracket outer hole,
then first pivot bracket, pivot spacer, second pivot bracket, and exit bottom hole of post bracket as shown below. Fasten a
M10 washer and M10 locknut on the end of the bolt. Finish by tightening both bolts on post bracket.