Manualshelf

Instructions / Assembly

ManualsBrandsGHOST CONTROLS ManualsAutomatic Gate OpenersArchitectural Series Solar Single Automatic Gate Opener Kit
11121314151617181920
20
DTP1 KIT
Ghost Controls 2017 | www.GhostControls.com
STEP 2. ESTABLISH AND MARK THE HORIZONTAL CENTER LINE OF THE GATE AND
THE POST FOR PROPER ALIGNMENT OF GATE BRACKETS.
NOTE
This center point will be used for mounting the post bracket in STEP 4.
STEP 3. POST BRACKET PREASSEMBLY.
Insert the M10x1.5x75mm bolt and M10 washer through the hole that is closest to the
post on the post bracket. Bolt should then go through first pivot bracket, pivot spacer,
second pivot bracket, and exit bottom hole of post bracket as shown below. Fasten
a M10 washer and M10 locknut on the end of each the bolts. DO NOT
overtighten the nuts because the post bracket may need to be adjusted
later.
PIVOT BRACKET
PIVOT BRACKET
NYLON PIVOT SPACER
COMPLETED ASSEMBLY
M10 X 1.5 X 75MM BOLT
M10 WASHER
M10 WASHER
M10 LOCKNUT
POST BRACKET