Full Product Manual

60
PUSHTOOPEN
©Ghost Controls
®
2023
CANCELLING AUTOCLOSE TIME ON YOUR GATE
NOTE
Canceling AUTOCLOSE can only be performed when the gate opener is idle.
Cancelling AUTOCLOSE will remove your previous duration setting and force you to pick a new duration the next time
you enable AUTOCLOSE. You can use PartyMode
®
to temporarily disable AUTOCLOSE and the system will retain your
current AUTOCLOSE duration when PartyMode
®
is disabled. Turning the control board o will not remove AUTOCLOSE
because turning the system back on will automatically reengage the AUTOCLOSE feature.
A. Press and hold the
SET AUTOCLOSE TIME button until it beeps.
B. Release the SET AUTOCLOSE TIME button. The LED next to the AUTOCLOSE button will start
blinking at the rate of 1 blink per second
C. Within 5 seconds, press and release the
SET AUTOCLOSE TIME button, you will hear a single beep
indicating the feature has been disabled.
D. The AUTOCLOSE feature is now disabled until you enable it with a new setting. IF THE AUTOCLOSE LED
IS STILL ON, THE AUTOCLOSE HAS NOT BEEN DISABLED (REPEAT STEPS A-B-C.)
AUTOCLOSE LED INDICATOR
The AUTOCLOSE LED indicates which mode the gate system controller is currently in. Note, that this LED will turn OFF
after one minute of inactivity to conserve system power.
LED Solid On LED Blinking On & O LED O
AUTOCLOSE
is enabled
AUTOCLOSE is enabled but temporarily suspended
because PartyMode has been activated. Disabling
PartyMode will turn the LED back to a Solid On.
• AUTOCLOSE disabled.
• AUTOCLOSE LED has timed out due to
inactivity.