Full Product Manual

PUSHTOOPEN

©Ghost Controls

2023

FOR DUAL GATES: SETTING THE OPEN LIMITS

A. Locate the 1st extended limit settings on the control board

and press and hold the JOG OPEN button for the 1st gate until the

gate reaches the desired OPEN position. The gate can move only

if pressure is maintained. Releasing the JOG button will stop the

gate immediately. Once the 1st gate is in the desired OPEN

position then repeat for the 2nd gate with the 2nd

extended limit settings JOG OPEN button.

B. Both JOG OPEN or JOG CLOSE buttons are needed to ‘ﬁne’ tune your

desired OPEN position.

. Press and hold the 1st set limit button on the control panel until it beeps, then release.

Then Press and hold the 2nd set limit button until it beeps, then release.

D. Press the transmitter button to activate the gates and let the gates close fully you should hear a single beep.

When the gates reach their CLOSED

position, the control board will sound a single beep, confirming the OPEN

limit has been set.

Conﬁrm the newly programmed OPEN limit by pressing the remote transmitter button to activate the gates and

conﬁrm the OPEN position has been set correctly. This limit is stored and remembered even when all of the power

sources are removed.

F. Repeat if needed to change your desired OPEN positions.

. Test your system with the remote transmitter to make sure it opens and closes without

errors.

1ST SET LIMIT SETTINGS

2ND SET LIMIT SETTINGS