Full Product Manual

PUSHTOOPEN

F. Align the innermost hole of the estate and front mount brackets and insert (1) M8 x 65mm flat washer,

and (1) M8 nylon locknut through both holes and tighten to secure the bracket to the gate. YOUR FRONT

MOUNT AND ESTATE BRACKET SHOULD NOW BE ATTACHED AND SECURED TO THE GATE.

G. Align and attach arm of operator to the

secured front mount bracket, as shown

below. Make sure all parts installed

during installation are tightened down.

STEP 15. IF ADDING A SECOND GATE OPERATOR REPEAT STEPS 1  14 SKIP STEPS 7 & 8

NOTE

For second operator you will need to dig a trench and use pvc conduit to put second operator power cables thru to connect

to the control box (2nd Operator Terminals) on the opposite side of the driveway.

STEP 16. DUAL GATE ONLY: INSTALL THE POSITIVE STOP PLATE.

Use the supplied Positive Stop Plate and hardware to install the Positive Stop Plate on the OUTSIDE OF THE FIRST

OPERATOR GATE as shown in the image below.

STEP 17. PROCEED TO PROGRAMMING THE OPEN LIMIT SETTING.

Align and bolt the

innermost hole

of Estate Bracket and

Front Mount Bracket