Full Product Manual

PUSHTOOPEN

B. Install the front mount gate bracket and estate bracket on the gate by

aligning the outermost hole and inserting (1) M8 x 65mm flat washer,

and (1) M8 nylon locknut through gate and front mount bracket,

as show below. Tighten to secure the brackets to the gate.

MAKE SURE GATE IS STILL IN CLOSED

POSITION (arm must be fully retracted).

C. Disconnect operator from gate bracket and swing away from the gate.

D. Assemble clevis pin, front spacer and hair pin to operator to prevent loss.

E. Now you can mark and drill the inner most hole on the

front mount bracket, shown below.

NOTE: It might be necessary to

remove the bracket to drill hole

Drill hole

Estate Bracket install

on backside of gate

Front Mount Bracket