Full Product Manual

PUSHTOOPEN

©Ghost Controls

2023

B. Now install the pre-assembled tubular clamp bracket over the center-most bar on your tube gate with the

gate at the open position.

C. Insert (2) M8 x 65mm flat washers, and (2) nylon locknuts as shown below through the tube gate bracket and

TIGHTEN NUTS TO SECURE THE TUBULAR CLAMP BRACKET TO THE GATE.

OPTIONAL: drill holes in gate to take

advantage of the second holes. This provides

additional front mount stability*

*These nuts and bolts not included*

STEP 14B. Mounting the FRONT MOUNT AND ESTATE BRACKET to gate. The gate must

remain in the desired closed position. *The estate bracket is not included in all kits.

CLOSE THE GATE TO THE DESIRED CLOSED POSITION

(this will be the position that your gate will always close to)

A. Line up the pre-assembled front mount gate bracket over the center-most bar on your gate and mark the

center location of the outermost hole on the gate.

NOTE

DO NOT SCREW THE OPERATOR ARM IN OR OUT TO ADJUST YOUR GATE POSITION. DOING SO

CAUSES THE SYSTEM TO NOT FUNCTION PROPERLY.

Drill hole