Full Product Manual

PUSHTOOPEN

©Ghost Controls

2023

WARNING

DO NOT SCREW THE OPERATOR ARM IN OR OUT TO ADJUST YOUR GATE POSITION. DOING SO

CAUSES THE SYSTEM TO NOT FUNCTION PROPERLY.

TURN THE CONTROL BOX OFF

STEP 13A. FOR ROUND TUBE GATES attach the front mount using the tube gate brackets.

(if don’t have tube gate brackets (AXTB) follow Steps 14A and 14B)

NOTE

ALTERNATE TUBE GATE BRACKETS FOR MOUNTING TUBULAR GATES. (NOT FOR USE WITH FLAT PANEL

GATES) see below image. Tube brackets (AXTB).

A. Before assembling gate bracket make sure the (2) tube clamp brackets fit over the tubular gate bar. If not

they will need to be flared before continuing on to next step.

NOTE:

Tube gate brackets ﬁt on gate tubes from 1 5/8" to 2"

B. Pre-assemble the tubular clamp brackets to the gate bracket by using the supplied gate and front mount

hardware. Insert (2) M8-65mm Hex Screws and (2) M8 Flat Washers through the Gate Mount Bracket holes

and attach to the Tubular Clamp Brackets and finish by inserting (2) M8- Flat Washers and (2) M8-Hex Nuts

to back of Clamp Brackets. GO TO STEP 14A.

STEP 13B. FOR FLAT OR DECORATIVE PANEL GATES attach front mount bracket to the

operator. The gate must remain in the desired closed position.

CLOSE THE GATE TO THE DESIRED CLOSED POSITION