Manualshelf

Full Product Manual

ManualsBrandsGHOST CONTROLS ManualsAutomatic Gate OpenersD Series Single Smart Ready Automatic Gate Opener Kit with Tube Gate Brackets
41424344454647484950
46
PUSHTOOPEN
©Ghost Controls
®
2023
CONNECTING OPERATOR ARM TO CONTROL BOX
STEP 9. Insert the operator cables into the control box.
A. Route the operator cable through the strain relief and into the control box.
B. Connect the operator wires to the control board. Find the 1st operator screw terminal on control board
and insert the red, black, green and white wires (left to right) into the matching color coded terminals
and tighten each of the screws so that the wires do not come loose and fall out.
*FOR DUAL GATES: You will connect the second operator wires later into the 2nd operator screw terminal.
C. Make sure wires are not inserted too far into the terminal slots and that the wire insulation is not interfering
with contact to the system control board.
D. Tighten strain relief nuts on the control box to close the seals around the wires.
B