Full Product Manual

PUSHTOOPEN

©Ghost Controls

2023

INSTALLING THE CONTROL BOX AND BATTERY BOX KIT* OR

12V MARINE BATTERY TO YOUR PUSHTOOPEN SYSTEM

(*Shown below using a BATTERY BOX KIT (ABBT2), OPTIONAL AND NOT INCLUDED IN MOST KITS)

STEP 7. Determine the mounting location for the control box and *optional battery box. The battery

and control box must be located within 4 feet of each other. Then install.

NOTE

Mount the control box a minimum of 3 feet above the ground to keep dirt and water from damaging the control board

and within 4 feet of the operator arm in order for the operator cable to reach the control box.

A. Pre-drill (4) holes (7/32˝ drill bit) in backside of control and optional battery box, and through the fencing

where you will be securing the control box and battery box.

B. Now use the (4) supplied phillips screws for each box to mount the control box and optional battery box to

the fence.

C. Make sure the on/off switch on the bottom of control box is in the off position.