Full Product Manual

PULLTOOPEN

D. Assemble clevis pin, front spacer and hair pin to operator to prevent loss.

E. Now you can mark and drill the inner most hole on the front mount bracket with a 5/16” drill bit, shown

below.

NOTE: It might be necessary to remove the bracket to drill hole.

Mark and drill the center location of

the innermost hole for the Gate Bracket

F. Align the innermost hole of the estate and front mount brackets and insert (1) M8 x 65mm flat washer, and (1)

M8 nylon locknut through both holes and tighten to secure the bracket to the gate. YOUR FRONT MOUNT

AND ESTATE BRACKET SHOULD NOW BE ATTACHED AND SECURED TO THE GATE.

Align and bolt the

innermost hole

of Estate Bracket and

Front Mount Bracket