Manualshelf

Full Product Manual

ManualsBrandsGHOST CONTROLS ManualsAutomatic Gate OpenersD Series Single Smart Ready Automatic Gate Opener Kit with Tube Gate Brackets
21222324252627282930
29
PULLTOOPEN
©Ghost Controls
®
2023
WARNING
DO NOT SCREW THE OPERATOR ARM IN OR OUT TO ADJUST YOUR GATE POSITION. DOING SO
CAUSES THE SYSTEM TO NOT FUNCTION PROPERLY.
Drill the outermost
hole with a 5/16” drill bit
Mark center
location of
outermost hole
CL
CL
Outermost hole
has been drilled
B. Install the front mount gate bracket and estate bracket on the gate by aligning the outermost hole of
both brackets and inserting (1) M8 x 65mm flat washer, and (1) M8 nylon locknut through both the
estate and front mount bracket, as show below. Tighten to secure the brackets to the gate. MAKE SURE
GATE IS STILL IN OPEN POSITION (arm fully retracted).
Estate Bracket install
on backside of gate
Front Mount Bracket
C. Disconnect operator from gate bracket and swing away from the gate.
Remove the clevis pin,
hair pin, and front spacer.