Full Product Manual

28
PULLTOOPEN
*Your Ghost Opener Arm might look different than illustrations through out this manual
B. Now install the pre-assembled tubular clamp bracket over the center-most bar on your tube gate with the gate
at the open position.
C. Insert (2) M8 x 65mm flat washers, and (2) nylon locknuts as shown below through the tube gate bracket and
TIGHTEN NUTS TO SECURE THE TUBULAR CLAMP BRACKET TO THE GATE.
OPTIONAL: drill holes in gate to take
advantage of the second holes. This provides
additional front mount stability*
*These nuts and bolts not included*
STEP 14B. Install the FRONT MOUNT BRACKET AND ESTATE BRACKET* to the gate.
*The estate bracket is not included in all kits.
OPEN THE GATE TO THE DESIRED OPEN POSITION
(this will be the position that your gate will always open to)
A. Line up the pre-assembled front mount gate bracket over the center-most bar on your gate and mark the
center location of the outermost hole on the gate.