Instructions / Assembly

61
PROGRAMMING
Ghost Controls 2017 | www.GhostControls.com
SETTING AUTOCLOSE
Minimum
AUTOCLOSE Time
Period
Maximum
AUTOCLOSE Time
Period
5 Seconds 60 Minutes. If longer
time is needed, you should
enable PartyMode or
Disable AUTOCLOSE.
The AUTOCLOSE TIME setting determines how long the
gate will remain open each time it operates before auto-
matically closing. The factory default setting is o which
requires the user to push either a remote transmitter
button, keypad code, or pushbutton to close the gate.
NOTE
The AUTOCLOSE time period begins once the gate has
reached its open limit.
1. Press and hold the SET AUTOCLOSE TIME button
(shown below) on the Control Board until the system
alarm sounds and the LED stays lit.
2. Release the button and begin monitoring your open
time on a clock or count the number of times the LED
blinks (1 blink per second).
3. When the desired AUTOCLOSE time is reached (no less
than 5 seconds or more than 60 minutes), press and
release the SET AUTOCLOSE TIME button.
4. The AUTOCLOSE feature is now enabled.
CANCELLING AUTOCLOSE
NOTE
Canceling AUTOCLOSE can only be performed when
the gate opener is idle.
Cancelling AUTOCLOSE will remove your previous
duration setting and force you to pick a new duration the next
time you enable AUTOCLOSE. You can use PartyMode™ to
temporarily disable AUTOCLOSE and the system will retain
your current AUTOCLOSE duration when PartyMode™
is disabled. Turning the control board o will not remove
AUTOCLOSE because turning the system back on will
automatically reengage the Auto-Close feature.
1. Press and hold the SET AUTOCLOSE TIME
button (show here) on the system control board
until the alarm beeps and the LED next to the auto-
close button stays lit (approximately 1 second).
2. Release the SET AUTOCLOSE TIME button. The LED
next to the autoclose button will start blinking at the
rate of 1 blink per second.
3. Within 5 seconds, press and release the SET
AUTOCLOSE TIME button to disable the autoclose
feature.
4. The AUTOCLOSE is now disabled until you enable it
again with a new setting.
AUTOCLOSE LED INDICATOR
The AUTOCLOSE LED indicates which mode the gate
system controller is currently in. Note, that this LED
will turn OFF after one minute of inactivity to conserve
system power.
LED Solid
On
LED Blinking
On & O
LED O
AUTOCLOSE
is enabled
AUTOCLOSE is
enabled but tem-
porarily suspended
because PartyMode
has been acti-
vated. Disabling
PartyMode will turn
the LED back to a
Solid On.
Assuming system
has been active
within the last
minute, this
indicates that
AUTOCLOSE is
disabled.