Instructions / Assembly

53
BATTERY BOX
©Ghost Controls 2017 | www.GhostControls.com
STEP 4: CONNECT THE BATTERY OR BATTERIES IN THE BATTERY BOX
Make sure to check for the proper polarity of wires. One or two batteries can be connected. Red connector goes on
positive battery terminal first and black connector goes on negative terminal of battery.
Connect the battery power cable terminals to the batteries in the Battery Box;
an optional second battery is shown. Connect the red wire leads to the
positive (+) terminals, and connect the black wire leads to the negative (-)
terminals. Place the batteries into the battery box once they are connected.
Once connected, pull slack out of the battery power cable, coil the excess
wire, and place it inside of the Battery Box.
Tighten the Strain Relief Nuts of both the Control Box and the Battery Box to
close the seals around the wires. DO NOT OVERTIGHTEN.