Instructions / Assembly

49
CONTROL BOX
©Ghost Controls 2017 | www.GhostControls.com
BLACK RED
STEP 7. ADDING A SOLAR PANEL OPTIONAL TO THE CONTROL BOX
When wiring a Solar Panel you will need to remove the plug in the negative solar terminal on the main control board and
then connect the solar panel wires to the matching terminals 1 and 3 on the SOLAR PWR INPUT screw terminal on the
control board. Please refer to diagram below. DO NOT HOOK UP AC TRANSFORMER IF USING SOLAR POWER.
STEP 8. HOOK UP YOUR BATTERY. GO TO INSTALLING THE BATTERY BOX CHAPTER.
STEP 6. ROUTING THE AC TRANSFORMER CABLE INTO THE CONTROL BOX
A. When wiring the AC Transformer you will need to insert the AC wires in the matching terminals 2 and 3 on
the 16 VAC PWR INPUT screw terminal on the main control board and tighten each screw so that the wires
do not come loose and fall out. Please refer to diagram below. DO NOT HOOK UP SOLAR IF USING AC
TRANSFORMER.
DO NOT PLUG IN THE AC
TRANSFORMER DURING THIS STEP.
B. Connect AC Transformer to outdoor outlet. Make sure you connect AC Transformer wires to control board
prior to plugging in AC Transformer into weatherproof outdoor outlet. Please refer to diagram below.