Instructions / Assembly

43
PULL-TO-OPEN
Ghost Controls 2017 | www.GhostControls.com
STEP 11. INSTALLING POSITIVE STOP PLATE
Determine location for Positive Stop Plate and mark the location of the (4) holes you need to drill on the gate.
Once holes are drilled use the supplied Positive Stop Plate and bolts to install the Positive Stop Plate on the OUTSIDE of
the first operator gate as shown in the image below.
STEP 12. TIGHTEN ALL PARTS
Make sure all parts installed during installation are tightened down.
STEP 13. GO TO INSTALLING THE CONTROL BOX CHAPTER, PAGE 45.
NOTE
ALTERNATE TUBE GATE BRACKETS FOR MOUNTING TUBULAR GATES. (NOT FOR USE WITH FLAT
PANEL GATES) see below image. Tube brackets (AXTB) sold separately.