Instructions / Assembly

37
PUSH-TO-OPEN
Ghost Controls 2017 | www.GhostControls.com
STEP 6. DRILLING REAR BRACKET HOLES AND BOLTING.
A. With the post bracket still clamped to post you will need a 3/8” drill bit and drill the (4) holes to mount the
rear bracket to the post.
TIP: Drill each hole one at a time and insert a bolt through to ensure that the holes are all aligned.
B. Insert (1) M-10-175mm bolt, and (1) flat washer thru the rear post bracket hole on the post and secure on
backside with (1) flat washer and (1) M10 locknut as shown and loosely tighten to secure the rear bracket
to the post. Repeat this 3 more times for the other bolts. Once all 4 bolts are in place you can firmly
tighten them
STEP 7. FINISHING POST BRACKET ASSEMBLY.
After verifying the required dimensions in STEP 5 and the rear post bracket is mounted in STEP 6, place the secondary
bolt into the push-to-open brackets as shown. Be sure to include the nylon pivot spacer as indicated. Refer to STEP 3.
THE REAR POST MOUNT BRACKET ASSEMBLY SHOULD REMAIN CLAMPED TO THE POST DURING
THIS PROCESS.