Instructions / Assembly
34
DEP2 Kit
Ghost Controls 2017 | www.GhostControls.com
STEP 2. INSTALLING FIRST OPERATOR: ESTABLISH AND MARK THE HORIZONTAL
CENTER LINES OF THE GATE AND THE POST FOR PROPER ALIGNMENT OF
GATE BRACKETS.
NOTE
This center point will be used for mounting the post bracket in STEP 4.
STEP 3. POST BRACKET
PREASSEMBLY.
Insert the M10x1.5x75mm bolt and M10
washer through the inner center hole
(towards post on top of bracket) of the post
bracket. Bolt should then go through top of
push-to-open bracket, pivot spacer, second
push-to-open bracket, and then exit out
of bottom hole of post bracket as shown.
Fasten a M10 washer and M10 locknut on
the end of each the bolts. DO NOT over
tighten the nuts because the Push-To-Open
brackets may need to be adjusted later.
PUSH-TO-OPEN
BRACKET
PUSH-TO-OPEN
BRACKET
NYLON PIVOT SPACER
COMPLETED ASSEMBLY
M10 X 1.5 X 75MM BOLT
M10 WASHER
M10 WASHER
M10 LOCKNUT
POST
BRACKET