Instructions / Assembly

29
PULL-TO-OPEN
Ghost Controls 2017 | www.GhostControls.com
C. Install the gate and estate brackets on the gate by aligning the outermost hole of both brackets and
inserting (1) M8 x 65mm flat washer, and (1) M8 nylon locknut thru both the estate and gate brackets, as
show below. Tighten to secure the brackets to the gate. MAKE SURE GATE IS STILL IN OPEN POSITION
(arm fully retracted).
D. Disconnect operator from gate bracket and swing away from the gate.
Remove the clevis pin,
hair pin, and front spacer.
Estate Bracket install
on backside of gate
Gate Bracket