Instructions / Assembly

PULL-TO-OPEN

Ghost Controls 2017 | www.GhostControls.com

STEP 6. DRILLING REAR BRACKET HOLES AND BOLTING.

A. With the post bracket still clamped to post you will need a

3/8” drill bit and drill the (4) holes to mount the rear post

bracket to the post

TIP: Drill each hole one at a time and insert a bolt through to

ensure that the holes are all aligned.

B. Insert (1) M-10-175mm bolt, and (1) flat washer

thru the rear post bracket hole on the post and

secure on backside with (1) flat washer and (1) M10

locknut as shown and loosely tighten to secure the

rear bracket to the post. Repeat this 3 more times

for the other bolts. Once all 4 bolts are in place you

can firmly tighten them.

STEP 7. FINISHING POST BRACKET ASSEMBLY.

After verifying the required dimensions in STEP 5 are done and the rear post bracket is mounted in STEP 6, place the

secondary bolt into the pivot brackets as shown. Be sure to include the nylon pivot spacer as indicated. Refer to STEP 3.

THE REAR POST MOUNT BRACKET ASSEMBLY SHOULD REMAIN CLAMPED TO THE POST DURING

THIS PROCESS.