Instructions / Assembly

22
DEP2 Kit
Ghost Controls 2017 | www.GhostControls.com
STEP 2. INSTALLING FIRST OPERATOR: ESTABLISH AND MARK THE HORIZONTAL
CENTER LINES OF THE GATE AND THE POST FOR PROPER ALIGNMENT OF
GATE BRACKETS.
NOTE
This center point will be used for mounting the post bracket in STEP 4.
STEP 3. POST BRACKET PREASSEMBLY.
Insert the M10x1.5x75mm bolt and M10 washer through the inner center
hole (towards post on top of bracket) of the post bracket. Bolt should then go
through pivot bracket, pivot spacer, second pivot bracket, and then exit out of
bottom hole of post bracket as shown below. Fasten a M10 washer and M10
locknut on the end of each the bolts. DO NOT over tighten the nuts because
the post bracket may need to be adjusted later.
PIVOT BRACKET
PIVOT BRACKET
NYLON PIVOT SPACER
COMPLETED ASSEMBLY
M10 X 1.5 X 75MM BOLT
M10 WASHER
M10 WASHER
M10 LOCKNUT
POST
BRACKET