Instructions / Assembly

AXZLIM | REV 0118

CONNECTING LOCK TO THE CONTROL BOX

STEP 1: VERIFY SWITCH AT CONTROL BOX IS OFF

STEP 2: RUN THE ZOMBIELOCK WIRES FROM GATE LOCK TO THE CONTROL BOX

Run the wire across the cross section of the bar into the control box.

STEP 3: CONNECT THE WIRES FROM GATE LOCK TO CONTROL BOX

Connect the gate lock wires to the LOCK

terminals on the control board. Once the

red, black, and blue wires are connected

to the terminals, tighten each of the

screws so that the wires do not come loose.

■ Red wire connects to positive (+)

■ Black wire connects to negative (–)

■ Blue wire connects to S (S)

STEP 4: CONTROLLER WILL

AUTOMATICALLY DETECT THE LOCK

WHEN SWITCH IS TURNED ON

■ Lock (if present) will be pulled (unlocked) for a

few seconds at the closed position before open-

ing. If lock is not completely pulled the gate will

not open to prevent damage to the gate and lock.

■ Lock will also be pulled (unlocked) near the closed

limit position when it is closing to ensure a smooth

and “soft” closing operation.

STEP 5: RECONNECT OPERATOR ARM TO FRONT GATE BRACKET WITH CLEVIS PIN AND CLEVIS HAIRPIN

NOTE

MAKE SURE THE GATE LOCK CLOSES FIRMLY IN THE RECEIVER, SOME ADJUSTMENTS OF GATE

CLOSURE MAY BE NECESSARY. REFER TO YOUR GATE OPENER MANUAL FOR THE CLOSED POSITION

ADJUSTMENT.

BLUE

BLACK

RED

GATE LOCK WIRE

WARNING: This product can expose you to chemicals including

lead, which is known to the State of California to cause cancer.

For more information, go to www.P65Warnings.ca.gov.