Full Product Manual

AXZLIM | REV 0217

STEP 2: RUN THE ZOMBIELOCK WIRES FROM GATE LOCK TO THE CONTROL BOX

Run the wire across the cross section of the bar into the control box.

STEP 3: CONNECT THE WIRES FROM GATE LOCK TO CONTROL BOX

Connect the gate lock wires to the LOCK terminals on the control board. Once the red, black and blue wires are connected to

the terminals, tighten each of the screws so that the wires do not come loose.

■ Red wire connects to positive (+)

■ Black wire connects to negative (–)

■ Blue wire connects to S (S)

BLUE

BLACK

RED

STEP 4: CONTROLLER WILL AUTOMATICALLY DETECT THE LOCK WHEN SWITCH IS TURNED ON

■ Lock (if present) will be pulled (unlocked) for a few seconds at the closed position before opening. If lock is not completely pulled the

gate will not open to prevent damage to the gate and lock.

■ Lock will also be pulled (unlocked) near the closed limit position when it is closing to ensure a smooth and “soft” closing operation.

STEP 5: RECONNECT OPERATOR ARM TO FRONT GATE BRACKET WITH CLEVIS PIN AND HAIRCLIP

NOTE

MAKE SURE THE GATE LOCK CLOSES FIRMLY IN THE RECEIVER, SOME ADJUSTMENTS OF GATE

CLOSURE MAY BE NECESSARY. REFER TO YOUR GATE OPENER MANUAL FOR THE CLOSED POSITION

ADJUSTMENT.

GATE LOCK WIRE