Full Product Manual

ManualsBrandsGHOST CONTROLS ManualsFencingZombieLock Automatic Gate Lock for Automatic Gate Openers

AXZL ZOMBIELOCK

AUTOMATIC GATE LOCK

INSTALLATION INSTRUCTIONS

WHAT IS INCLUDED IN AXZL KIT:

MOUNTING THE LOCK AND RECEIVER:

NOTE: If your gate is set up in the push-to-open mode, the lock will need to be installed on the outside of the gate.

STEP 1: DISCONNECT FRONT END OF GATE OPERATOR ARM FROM GATE BRACKET

NOTE: For DUAL gates you will need to disconnect both operator arms from the gate.

You must disconnect the operator only after the operator power switch is OFF and the gate is NOT moving.

1. Move the gate operator control box switch to the o position.

NOTE: The gate operator is battery powered and unplugging the AC transformer does not turn the power to the operator o.

2. Remove the hairpin clip and clevis pin from the FRONT mount of the gate operator.

3. Swing the operator arm out of the way of the gate.

GATE LOCK

Summary of content (4 pages)

PAGE 1
AXZL ZOMBIELOCK® AUTOMATIC GATE LOCK INSTALLATION INSTRUCTIONS WHAT IS INCLUDED IN AXZL KIT: MOUNTING THE LOCK AND RECEIVER: NOTE: If your gate is set up in the push-to-open mode, the lock will need to be installed on the outside of the gate. STEP 1: DISCONNECT FRONT END OF GATE OPERATOR ARM FROM GATE BRACKET NOTE: For DUAL gates you will need to disconnect both operator arms from the gate.
PAGE 2
STEP 2: MAKE SURE GATE IS IN THE CLOSED POSITION To support the gate in the closed position you should wire tie or clamp the gate. This will let you swing the gate manually while installing the gate lock. Lock should be mounted on the gate cross member or other solid part of the gate surface and the receiver should be mounted on the adjacent post perfectly level with the lock. See illustration below. NOTE: SCREW NUTS ONTO THE TUBE BRACKETS BEFORE ATTACHING TO THE LOCK.
PAGE 3
Mounting on DUAL tube gates RECEIVER AND PIN OPTIONAL AXTB TUBE BRACKETS LOCK KEYS STEP 3: VERIFY THE RECEIVER PIN LINES UP WITH SLOT IN THE LOCK The gate lock needs to be level with the receiver. RECEIVER AND PIN LOCK View looking down showing receiver pin lines up with gate lock STEP 4: DRILL HOLES ON THE POST AND ATTACH RECEIVER WITH INCLUDED NUTS AND BOLTS See illustrations in STEP 2.
PAGE 4
STEP 2: RUN THE ZOMBIELOCK WIRES FROM GATE LOCK TO THE CONTROL BOX Run the wire across the cross section of the bar into the control box. GATE LOCK WIRE STEP 3: CONNECT THE WIRES FROM GATE LOCK TO CONTROL BOX Connect the gate lock wires to the LOCK terminals on the control board. Once the red, black and blue wires are connected to the terminals, tighten each of the screws so that the wires do not come loose.