Instructions / Assembly

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
■ This device may not cause harmful interference
■ This device must accept any interference received, including interference that may cause undesired
operation.
WARNING G
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE DDFDFDFDFDFDFDFDF FDFDFDFDFDFDDFDF
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
■ Reorient or relocate the receiving antenna
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
■ Consult the dealer or an experienced technician for help.
REMOTE TRANSMITTER OVERVIEW
STANDARD REMOTE
INSTRUCTIONS
PROGRAMMING
All GHOST CONTROLS
®
remote transmitters must be programmed before they will operate the Gate
Operator System so that the safety and security of your system is maintained.
Programming Remote to Gate Controller
Step LED/Alarm
Before Pressing
Button(s)
Sequence to Press
LED/
Alarm After
Pressing
Description
1 Press & hold LEARN
XMTR button on
gate system controller
Gate alarm
sounds and
LEARN XMTR
LED on system
controller stays
Places gate controller into Learn Remote
mode for 10 seconds. NOTE-The gate
system controller will exit the Learn
Remote mode after 15 seconds and return
to normal operation if there is no valid
remote transmitter signal received.
2 Gate controller
LED is
Press & hold or
Gate controller
alarm beeps
or gate begins
moving
Programs this button into memory.
3
Release the or
LEARN XMTR
LED goes
The new transmitter’s ID has been saved
into the memory of the main system
controller.
4 No alarm sounds,
LEARN XMTR
LED on main
controller is
LED on remote is
Press and release the
or
button
Transmitter
LED blinks on
when button is
depressed
Tests the transmitter button you just
programmed. LED on transmittter turns
on only when button is depressed to
indicate it is transmitting ZombieCode
®
signal to gate controller. Each press of
this remote button will cycle the gate as
follows: OPEN-STOP-CLOSE-STOP-
OPEN. The LED will be flashing rapidly
when the transmitter is transmitting.
Maximum transmitting time is approximately
20 seconds to save battery life.
Add An Additional Remote Transmitter To Control the Gate
Step LED/Alarm
Before Pressing
Button(s) Sequence
to Press
LED/Alarm After
Pressing
Description
1
Press & hold the
on Remote B
(Learning) for at
least 3 seconds or until
the LED goes
Remote LED is This process assume that there is a
remote that is ALREADY capable of
controlling the gate. Puts Remote B
into Learning Mode.
2
Press & hold or
on Remote A,
the Teaching
Remote.
LEDs on both
Teaching and
Learning Remote
are
Remote A, Teaching Remote is in
Teach Mode, and Remote B, Learning
Remote is in Learn Mode.
3
Press & release
or on Remote
B, the Learning
Remote.
Remote LED goes Indicates that Learning remote
button pressed in this step is now
programmed to operate the same gate
as the button pressed in step 2 on the
Teaching remote operates.